How to clean and maintain the tto print head of 8018TTO thermal transfer Overprinter?

How to clean and maintain the tto print head of 8018 Thermal Transfer Overprinter? moment, the small editor of unioncoding will give you a detailed preface.

1 、 Maintain Thermal Transfer Overprinter tto print head

Although it's especially designed according to the operation of the tto print head, the print head will be worn or broken. For the tto print head, special consideration should be given during installation and preventative conservation should be carried out regularly, which is veritably helpful to protract the service life of the tto print head.

The most likely cause of tto print head damage is wear irruption of air patches or rough substrate face. thus, the tto print head life varies greatly depending on the substrate material and operation.

The heat transfer rendering strip protects the tto print head from wear and tear. The unused and vulnerable corridor of the tto print head may be worn and damaged by using color bands of different extents and rough substrates. generally, a rough substrate has a preprint essay. In particular, some red inks may be coarserthan others.

The operation way of all heat conduction printers are as follows

• clean the ttp print head regularly. The frequence of drawing depends entirely on the specific operation and terrain.

• in order to minimize the wear and tear of the tto print head, the minimum Pressure.

2 、Cleaning  the heat transfer printer tto print head

The tto print head should be gutted regularly. The cleaning frequence depends on the use of the outfit, the operating terrain and the selection of the heat transfer printing strip.

1. turn off the regulator and remove the strip.

2. to avoid the possibility of heat conduction vibration damage, cool the tto print head temperature to the normal inner temperature before continuing printing.

3. use a cotton ball or soft cloth soaked in isopropyl alcohol result to remove any residue on the tto print head. Pay attention not to use too important isopropyl alcohol. The print line is on the slant of the tto print head.

Cleaning of heat transfer printer tto print head

Be careful not to damage the tto print head during cleaning. When drawing the tto print head, under no circumstances should rough face accoutrements or tools( similar as screwdriver) be used.

Replace the strip and check the printquality.However, the tto print headmay need to be acclimated or replaced, If the overall quality is poor or some fleck matrices aren't published.